Variable Speed Control; Switching On And Off - Black & Decker KS900E Mode D'emploi

ENGLISH
•
Impairment of hearing.
•
Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech
and MDF).
Use
Adjusting the shoe plate for
bevel cuts (fig. F and G)
Warning! Never use the tool when the shoe
plate is loose or removed.
The shoe plate (7) can be set to a left or right
bevel angle of up to 45°.
•
Pull the shoe plate locking lever (5) outwards
to unlock the shoe plate (7) from the 0 deg
position.
•
Pull the shoe plate (7) forward and set the
required bevel 15°, 30° and 45° indicated in
the bevel angle window.
•
Push the shoe plate locking lever (5) back
towards the saw to lock the shoe plate (7).
To reset the shoe plate (7) for straight cuts:
•
Pull the shoe plate locking lever (5) outwards
to unlock the shoe plate (7).
•
Set the shoe plate (7) to an angle of 0° and
push the shoe plate backwards.
•
Push the shoe plate locking lever (5) back
towards the saw to lock the shoe plate (7).
Setting the pendulum stroke
(fig. H)
•
Set the pendulum stroke selector (9) to the
required position.
10
•
Position 0: metal and aluminium and sheet
metal.
•
Position I: for laminates, hard wood, work
tops.
•
Position II: for plywood and PVC/Plastics.
•
Position III: for soft wood and fast cutting.

Variable speed control

•
Set the variable speed control knob (1) to the
required speed range.
•
Use a high speed for wood, medium speed
for aluminium and PVC and low speed for
metals other than aluminium.

Switching on and off

•
To switch the tool on, press the on/off
switch (2).
•
To switch the tool off, release the on/off
switch (2).
•
For continuous operation, press the lock-on
button (3) and release the on/off switch (2).
•
To switch the tool off when in continuous
operation, press the on/off switch (2) and
release it.
Sawing
Hold the tool firmly with both hands while cutting.
The shoe plate (7) should be held firmly against
the material being cut. This will help prevent the
saw from jumping, reduce vibration and minimise
blade breakage.
•
Let the blade run freely for a few seconds
before starting the cut.
•
Apply only a gentle pressure to the tool while
performing the cut.