Sundance Spas Altamar 880 Serie Mode D'emploi page 65

Masquer les pouces Voir aussi pour Altamar 880 Serie:
Table des Matières

Publicité

2. Press the (UP)
of the CLEARRAY System from either "ON" to "OFF."
Note: If the "OFF" option is selected, then there is no need to continue
with the steps below. Selecting "OFF" disables the duration countdown
timer. Press the (CYCLE)
return to the water temperature display.
3. Press the (SELECT)
timer.
4. Press the (UP)
timer to 365 days. If the timer is not at "0" pressing the "UP"
button will not reset it.
Note: You can only program the duration if the number of days is at "0"
days or the LCD display is flashing "blb." Pressing the (UP)
ton at any other reading will not change it.
5. Press the (DISPLAY)
the water temperature display.
Note:
Flashing "blb" message: When the time allotted has expired (365
days) the display screen will flash between the water temperature
and "blb." The indicator light located on the front cabinet panel of
the spa will be lit red. At this time the UV bulb must be replaced,
the quartz tube must be cleaned and the duration countdown timer
needs to be reset.
If the spa power is interrupted, the timer is not affected. The num-
ber of days remaining is stored in the memory and will continue to
countdown once power is regained.
If you press the (UP)
to "OFF" and press the (UP)
will reset the timer back to 365 days.
or (DOWN)
then the (DISPLAY)
button to access the duration countdown
button to program the duration countdown
button to save changes and exit back to
button to "ON" then press the (DOWN)
button to change the status
button to "ON" again, you
880 SERIES
button to
but-
Page 59

Publicité

Table des Matières
loading

Table des Matières