Programmable Filter/Heating Cycles (Economy Mode Only) - Sundance Spas Altamar 880 Serie Mode D'emploi

12.2

Programmable Filter/Heating Cycles (Economy Mode Only)

Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump while in economy mode. These cycles are factory
programmed to start at 6:00 AM, 12:00 (noon), 6:00 PM, and 12:00
(midnight). The control system allows you to easily adjust two separate
aspects of each cycle:
• The time of day at which it begins;
• The duration of the cycle.
Note: When "Economy" mode is selected (Section 11.3), the heater
activates only during a programmed filter cycle period. When a Sum-
mer Logic condition is active (page 55), the filter/circulation pump will
turn on for all programmed filter cycles.
Summer Logic: In warm weather, the water temperature in the
hot tub may exceed the set temperature. This condition may occur
due to heat transference from the filter/circulation pump and jets
pumps. If the water temperature is higher than 95°F (35°C) and
rises two degrees above the set temperature, a "Summer Logic"
condition occurs that deactivates the filter/circulation pump and
CLEARRAY®. This safety feature cannot be altered! The filter/
circulation pump and CLEARRAY® will remain off until the water
temperature cools to the set temperature. A mandatory cycle runs
from 9am-11am only when the spa is in summer logic.
Note: Pressing the select button at this time will reactivate the
circulation pump and waterfall feature for 1 hour. To help prevent
a "Summer Logic" condition, it may be necessary to reduce filter/
circulation pump cycle run times in warm weather.
Press the (MODE)
adjustments, first press the (CYCLE)
cycle programming mode. The LCD screen will display the following in
the upper right corner:
This means the system is ready to accept you changes to the start time
for cycle number one. Simultaneously, the large four-digit display in the
center of the screen displays the currently programmed start time for that
cycle. At this point, you have four options. You may:
1. Press (UP)
increments of 30 minutes.
button to select "Economy" mode. To make
*
or (DOWN)
button to enter the filter
*Note: Number will vary
according to which filter
cycle is being programmed.
button to adjust the start time in
880 SERIES
Page 55