Sundance Spas Altamar 880 Serie Mode D'emploi page 81

*
* Note: This message can also appear if the pump has not regained
prime after the hot tub has been drained and refilled. If you suspect that
this is the case, see the instructions on page 77 under "pump does
not operate and icon does."
Note: This error commonly occurs when the hot tub is first filled be-
cause tap water is often very cold.
FLOW SWITCH (Heater is deactivated. The filter/
circulation may also be deactivated). Proper flow of water
is inhibited or a flow switch has malfunctioned. Check for
proper water level and for clogged filter (pages
60-62). Contact your Sundance Spas dealer or
qualified service technician.
Circuit board temperature has exceeded acceptable limit.
This message will disappear when the circuit board
temperature drops below acceptable limit. If condition
persists, provide shade for equipment side of hot tub.
FREEZE PROTECTION
A potential freeze condition has been detected. No action
is required. Jets pump(s) operate until the hot tub is out of
danger.
Power failure. Power fluctuation in the secondary power
line is causing the DC voltage to be low. Try to reset
power to spa. Should the power level return to normal, the
PF error will reset itself. If the error returns, contact your
Sundance Spas dealer or qualified service technician.
Communication between the control panel and/or remote
control panel and circuit board is faulty. Contact your
Sundance Spas dealer or qualified service technician.
WARNING: RISK OF HYPERTHERMIA
!
(OVER-HEATING) CAUSING SEVERE INJURY,
BURNS, OR WELTS.
"WATCHDOG" (hot tub is deactivated). Water temperature
is above acceptable limits. DO NOT ENTER THE
WATER! Remove hot tub cover to speed cooling. A
problem has been detected which could cause damage to
the hot tub or its components. Contact your Sundance
Spas dealer or qualified service technician.
880 SERIES
Page 75