Sundance Spas Altamar 880 Serie Mode D'emploi page 26

Masquer les pouces Voir aussi pour Altamar 880 Serie:
Table des Matières

Publicité

880 SERIES
Water Fill Volume
Model
Altamar ...............................390 Gal (1,476 L) .............................10.0 oz
Aspen .................................563 Gal (2,131 L) .............................14.0 oz
Cameo ................................370 Gal (1,401 L) ............................. 9.0 oz
Capri ...................................230 Gal (871 L) ................................ 6.0 oz
Majesta ...............................330 Gal (1,249 L) ............................. 8.0 oz
Marin...................................315 Gal (1,192 L) ............................. 8.0 oz
Optima ................................410 Gal (1,552 L) .............................10.25 oz
Maxxus ...............................570 Gal (2,158 L) .............................14.25 oz
*Use average fill volume for chemical maintenance
10. Leave hot tub cover open during this step to allow
excessive chemical vapors to exit hot tub, protecting
pillows and plastic knobs from chemical attack. If hot
tub is indoors, open doors and windows for proper
ventilation. Turn on all hot tub jets pumps for one hour, open all air
controls, turn on the blower, and place all massage selector knob(s)
in their center "combo" position as shown (right).
Note: You will need to press the jets pump button(s) and blower button
every 20 minutes since these functions have an automatic 20 minute
time-out function that turns them off.
WARNING:
!
To decrease the risk of injury, drowning or entrapment,
never leave your hot tub unattended for any reason while
the cover is open and accessible, especially to small
children and animals!
Precautions should be taken to minimize your exposure
to chemical vapors (that could cause lung, brain, or skin
damage).
11. Turn off power to the hot tub at the circuit breaker, then drain tub as
outlined in Section 13.3 (page 63).
12. Refill hot tub with clean tap water from garden hose until water
covers all jets but does not touch the bottom of the lowest headrest.
(DO NOT OVERFILL!)
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard," it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
Page 20
Average
Fill Volume*
RISK OF PERSONAL INJURY!
Sodium
Dichlor

Publicité

Table des Matières
loading

Table des Matières