Programming Instructions; Programming Filter/Circulation Pump - Sundance Spas Altamar 880 Serie Mode D'emploi

880 SERIES
12.0

Programming Instructions

12.1

Programming Filter/Circulation Pump

The control system allows you to easily adjust two separate aspects of
filter/circulation pump operation:
• The time of day (start time) the filter/circulation pump turns on.
• The length of time (duration) the filter/circulation pump operates.
The factory default start time is 12:00AM (midnight). The recommended
factory duration is 8 hours. To make adjustments:
• Standard Mode - in this mode, press the (CYCLE)
once;
• Economy Mode - in this mode, press the (CYCLE)
times to enter the filter/circulation pump programming mode.
Note:
• Any time the circulation pump runs (e.g. when heating) outside of a
programmed cycle, that run time will reduce the length of the next
cycle.
• A mandatory cycle runs from 9am-11am only when the spa is in
summer logic.
In extreme bitter cold weather we recommend you program
the circulation pump to run 24 hours. Refer to the "Winteriz-
ing" section on page 66.
The LCD screen will display "Circ." At this time the system is ready to
accept your changes.
1. Press the (SELECT)
start time appears on the LCD display.
2. Press the (UP)
time in 30-minute increments.
3. Press the (SELECT)
4. Press the (UP)
duration time in 1 hour increments.
5. Press the (DISPLAY)
main water temperature display.
Note: If no button is pressed within 30 seconds, all changes are
recorded and the screen automatically returns to the standard water
temperature display. When the standard mode is selected (Section
11.3), the filter/circulation pump automatically turns on for a heat call
regardless of the pump's programmed start time and duration.
Page 54
button once. The previously programmed
or (DOWN)
button to program duration.
or (DOWN)
button to save changes and recall the
button to adjust the start
button to program the
button
button five