Table des Matières
Publicité
HANDLEBAR
6. Install:
• Throttle cable cap 1
• Screw (throttle cable cap) 2
WARNING
After tightening the screws, check that the
throttle grip 3 moves smoothly. If it does
not, retighten the bolts for adjustment.
7. Install:
• Grip cap cover 1
• Cover (throttle cable cap) 2
8. Install:
• Brake master cylinder 1
• Brake master cylinder bracket 2
• Bolt (brake master cylinder bracket) 3
NOTE:
• Install the bracket so that the arrow mark a
faces upward.
• First tighten the bolt on the upper side of the
brake master cylinder bracket, and then
tighten the bolt on the lower side.
5 - 46
CHAS
4 Nm (0.4 m · kg, 2.9 ft · lb)
9 Nm (0.9 m · kg, 6.5 ft · lb)
Publicité
Table des Matières
