Break-In Period - Ariens ProZoom 2760S Manuel D'utilisation

Floating Axle
Fixed Axle
Figure 9
OPERATION

Break-in Period

• Operation of the mower within the first fifty hours can
be a major factor in determining the performance and
life of the engine and power unit.
• The engine may be operated at full RPM, but
excessive load should be avoided. If engine begins to
slow, due to excessive load, operate at a slower
ground speed while maintaining the engine speed.
• Check engine, pumps, and motors frequently during
break-in period. Watch for evidence of leakage of
fluids. Replenish levels as required and repair any
leaks that may have formed.
• Locate any nuts, bolts or screws that may have
loosened and tighten them as necessary. This is
especially true of the wheel retaining nuts.
• During break-in period observe control arm and
parking brake adjustments. Parking brake adjustments
may be necessary after the first few hours of operation.
• Keep area around the fuel tank filler clean and make
sure the gasoline is of correct octane and free of
contamination.
• Initial oil and oil filter change is after the first 8 hours of
use and every 100 hours after.
CAUTION: Proper maintenance practices are
required for safe operation. (See Maintenance
Schedule on page 17.)
Fuel
WARNING: AVOID INJURY.
Read and understand entire Safety section
before proceeding.
Add fuel to the Fuel Tank as needed. See your engine
manual for correct type and grade of fuel.
To add fuel to the fuel tank:
1. Place unit in an open, well-ventilated area.
2. Stop engine and allow it to cool.
3. Clean the fuel cap and area around the fuel cap to
prevent dirt from entering the tank. Remove the cap
from the fuel tank.
4. Fill the fuel tank to within 1 in. (25mm) below bottom of
filler neck. Do not overfill.
5. Replace fuel cap and tighten.
6. Clean up any spilled fuel.
Mounting and Dismounting Safely
DO NOT step on either side of the mower deck when
mounting or dismounting the power unit. Step over the deck
when mounting or dismounting.
PRE-START INSPECTION
CAUTION: Make sure all hardware is tight, all
safety devices are in place and all adjustments
are made correctly.
Safe operation is the responsibility of the operator. The
operator MUST be familiar with the mower and power unit
controls, how they work, and all safety precautions BEFORE
starting operation.
IMPORTANT: Inspect the mowing blade bolts daily, or
whenever a blade has been removed. Torque is
110 – 130 lbf-ft. (150 – 177 N•m).
• Make sure all safety shields are in place and secured
properly.
• Make sure the operator is instructed on correct and
safe operation of the power unit and related
attachments and implements.
• Check engine and hydraulic reservoir oil and fill as
necessary.
• Check the pump belt and drive belt tension and adjust
as necessary.
• Ensure air intake screens are clear of debris to provide
maximum engine cooling.
• Inspect tires, tire pressure and wheel bolt torque. Look
for external signs of leakage and correct before
operating the mower. Check steering control levers for
looseness and correct position.
• Check for adequate fuel supply. It is recommended that
the fuel tank be filled following each day's use to reduce
condensation and provide a full tank for next use.
GB - 14