Publicité
Getting Connected and Installing Drivers (Windows)
5
Set the UA-700's power switch to the ON position.
fig.05-23e_30
6
Windows will detect the UA-700,
and the "Add New Hardware
Wizard" dialog box will appear.
Make sure that Automatic search
for a better driver
(Recommended) is selected, and
click [Next].
7
Driver detection will begin.
8
When the driver has been found, driver installation will begin.
fig.05-24e_30
9
Once the driver has been
installed, a dialog box will inform
you of this.
Click [Finish].
10
Restart Windows.
Next, you will need to make the driver settings.
(➝ Settings and checking (p. 33))
I Windows 98 users
The USB composite device driver is installed first, then the USB audio
device driver is installed. Use the following procedure to install the drivers.
1
With the UA-700 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB mouse
(if used).
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit it as well.
30
This unit is equipped
with a protection circuit.
A brief interval (a few
seconds) after power up
is required before the
unit will operate
normally.
Depending on your
system, a certain amount
of time may be required
for the device to be
detected after the driver
has been installed.
Publicité
Chapitres
