Publicité
Advanced applications
Switching patches from an external device
I Switching patches from a sequencer
Here's how the six patches stored in the UA-700 can be selected from your sequencer software.
1. Select [EDIROL UA-700 CONTROL] as the output destination for a MIDI track in your
sequencer software that contains MIDI data for switching patches.
2. When you transmit a program change (PC) message from your sequencer, the UA-700 will
switch patches.
Program changes and UA-700 patches correspond as follows.
PC #0 ➔ patch 1
PC #1 ➔ patch 2
PC #2 ➔ patch 3
PC #3 ➔ patch 4
PC #4 ➔ patch 5
PC #5 ➔ patch 6
*
Program changes are received on all channels.
I Switching patches from an external MIDI device
Even if the UA-700 is not connected via USB, you can use a MIDI foot controller such as the Roland
GFC-50 to switch UA-700 patches.
1. Connect your MIDI foot controller to the UA-700's MIDI IN connector.
2. When you transmit a program change (PC) message from your foot controller, the UA-700
patch will change.
PC #0 ➔ patch 1
PC #1 ➔ patch 2
PC #2 ➔ patch 3
PC #3 ➔ patch 4
PC #4 ➔ patch 5
PC #5 ➔ patch 6
142
Publicité
Chapitres
