Publicité
Application guide
Input audio from a CD/MD/DAT to your computer
Make connections as shown in the diagram.
fig.digital
DIGITAL
Input the sound
without change
Set the rear panel Record Source select switch to MIX if you want to mix the input from the Mic
input jacks or Guitar input jack together with the input signal from the Digital input jack and
record the mix. With this setting, you will be able to apply equalizer and chorus/reverb.
Set the rear panel Record Source select switch to DIGITAL if you want to directly input the signal
from the digital input jack without processing it. With this setting, the digital signal will be input
at its original high quality. You will not be able to apply equalizer or chorus/reverb. Nor will you
be able to record guitar or mic along with the digital input.
*
The UA-700 does not support the audio formats of professional digital audio devices.
Do not connect anything to the input jacks you are not using.
Built-in sample rate converter
The UA-700 can perform realtime sampling rate conversion of the signal that is input from the
digital input jack.
<Example>
48 kHz -> 44.1 kHz
32 kHz -> 48 kHz
The digital signal will be converted into the frequency specified by the Sample rate select switch
before it is recorded by your application.
Even when recording the digital output of a satellite receiver whose frequency switches
automatically, you can obtain high-quality digital recordings without changing the settings of the
UA-700 or of your application.
134
Optical
digital cable
Use either OPTICAL or
COAXIAL according to the
MIX
cable you are using.
Input the mixed and
effect-processed
sounds
Adjust the equalizer and
chorus/reverb
CD/MD/DAT player or
similar device
DIGITAL OUT
Coaxial
cable
Turn this ON if you want to
monitor the input directly
Signal flow
Set to match the
sampling frequency of
the digital device that is
connected.
Publicité
Chapitres
