Publicité
Getting Connected and Installing Drivers (Windows)
12
Use the USB cable to connect the UA-700 to your computer.
1. With the power switch turned OFF, connect the AC adaptor to the
UA-700.
2. Connect the AC adaptor to an electrical outlet.
3. Use the USB cable to connect the UA-700 to your computer.
fig.advance-on
13
Set the UA-700's ADVANCE (mode select)
switch to the ON position.
14
Set the UA-700's power switch to the ON position.
Near the task bar, your computer will indicate "Found New Hardware".
Please wait.
fig.2-6
15
The Found New Hardware
Wizard will appear.
Make sure that the screen
indicates "EDIROL UA-700
(WDM)", select "Install from a
list or specific location
(Advanced)", and click [Next].
fig.2-7
16
The screen will indicate "Please
choose your search and
installation options".
Select "Don't search. I will
choose the driver to install", and
click [Next].
18
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
Advance mode is
ON
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
In the case of the MME
driver, make sure that
"EDIROL UA-700 (MME)"
is displayed.
Publicité
Chapitres
