Operation; Storage; Loading The Filling Station; Loading By Hand - CEMO KS-Mobil 90 l Mode D'emploi

5. Operation

5.1 Storage

Do not expose the KS-Mobil to direct sunlight for
extended periods either during transport or when in
storage. Excessive heating can degrade the quality
of the high-grade plastic container.
If excess pressure occurs in the sealed container,
this is bled off via the safety valve e.
Suitable storage conditions:
• ambient temperatures from - 10 °C to + 40 °C.
• level surface.
• cover (tarpaulin) for storage outdoors.

5.2 Loading the filling station

Risk of injury!
Cover and clamp lock of the pump
enclosure must be closed.

5.2.1 Loading by hand

Empty KS-Mobil can be loaded by hand using the
handles on the side of the tank.
Note the weight
of the filling station
when empty
!
90 l = 60 kg
200 l = 77 kg
5.2.2 Loading with a forklift
Important!
i
Use the provided recesses on the
underside for safe lifting with a forklift.
Figure 5.2.1: KS-Mobil 200 l
Figure 5.2.2: KS-Mobil 200 l

5.2.3 Loading with a crane

Danger!
A KS-Mobil can cause severe injuries if
it falls.
Do not stand under suspended loads
during crane operations.
• Use the handles attached to the side of the tank
for crane operations.
• Fasten 4 suitable load attachments of equal
length (minimum length: 1 m) to the handles
• KS-Mobil can be loaded or unloaded onto or from
the transport vehicle.
Figure 5.2.3.1:
KS-Mobil 90 l

5.3 Transporting

During transport, observe the pertinent regulations
for transport and securing loads, in particular:
• road traffic (licensing) act of the country
in question,
• CEN 12195 Parts 1 to 4 for calculation
and lashing.
Thread the tensioning
handles when securing the filling station to the
transport vehicle.
Figure 5.3.1:
KS-Mobil 90 l
GB
Figure 5.2.3.2:
KS-Mobil 200 l
belts through the
Figure 5.3.2:
KS-Mobil 200 l
19