Basic Operations; I Turning Off The Power - JVC DLA-M2000LU Manuel D'instructions

(QJB'/$0ERRN 3DJH  7KXUVGD\ $XJXVW     $0

Basic Operations

I Projector's buttons
LAMP TEMP
OPERATE
HIDE
KEYSTONE VOLUME
PRESET
ESCAPE
I Remote control unit
FREEZE OPERATE
HIDE
PRESET MENU
ESCAPE VIC SELECT
PC
+
DIGITAL
ZOOM KEYSTONE VIDEO
–
+
U T
SHIFT ZOOM FOCUS
–
D W
+ +
QUICK
SHUTER ALIGN. VOLUME
– –
RM-M2000 REMOTE CONTROL UNIT
STAND BY indicator
STAND BY
OPERATE indicator
OPERATE button
PC
VIDEO
MENU
ENTER
OPERATE button
DLA-M2000LU/M2000SCU/ LCT0940-002A / ENGLISH
The following describes the basic procedure for normal use
of the projector.
1. Turning on the Power
1
Turn on the MAIN POWER switch.
ON [ ❙ ❙ ❙ ❙ ] : The main power turns on and the STAND BY
indicator comes on.
2
Press the OPERATE button for one
second or more.
• The OPERATE indicator lights and the projected
screen slowly appears.
Remote control unit
OPERATE
or
Notes
• After the power is turned on, the image may be jumbled for a
few seconds, but this is not a malfunction.
• After the indicator comes on, it can take a minute or so for
the lamp to warm up and operate consistently.

I Turning off the Power

1
Press the OPERATE button for one
second or more.
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode. The cool-down
mode will continue for approximately 120 seconds.
Remote control unit
OPERATE
Note
• The OPERATE button will not work for approximately 1
minute from when the light-source lamp is turned on. Use
the button after approximately 1 minute.
2
Turn off the MAIN POWER switch after the
STAND BY indicator changes to steady on.
OFF [‡ ‡ ‡ ‡ ] : The MAIN POWER switch turns off and the
STAND BY indicator goes off.
CAUTION
• Do not turn off the MAIN POWER switch during cool-down
mode (the STAND BY indicator blinking). Turn it off after
the STAND BY indicator becomes on (stand-by mode).
Projector's indicator
STAND BY
OPERATE
Projector
STAND BY
OPERATE
Projector (Blinking)
STAND BY
OPERATE
Projector
STAND BY
OPERATE
31