Basic Operations; Turning Off The Power - JVC D-ILA DLA-G20U Mode D'emploi

Basic Operations

Projector's buttons
STAND BY
OPERATE button
LAMP
2, 1
TEMP
EMERGENCY
MAIN POWER switch
VIDEO
COMPUTER
SETTING
+ 3
QUICK
ALIGN
- 2
Remote control unit
OPERATE
COMPUTER VIDEO 2, 1
T
VOL. ZOOM FOCUS
W
MENU/ENTER
PAGE
BACK
PRESET
QUICK AV
ALIGN. MUTING
26
STAND BY indicator
OPERATE indicator
1, 2
Touche OPERATE
The following describes the basic procedure for normal use of
the projector.
1. Turning on the Power
1 Turn on the MAIN POWER
switch.
ON [ ]:The main power turns on and the STAND BY
indicator comes on.
2 Press the OPERATE button for
one second or more.
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Remote control unit
OPERATE
Notes
• After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
• If the light-source lamp does not light up, try to press the OPERATE
button for more than a second again.

Turning off the Power

1 Press the OPERATE button for
one second or more.
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
Example of the projector's button
(ON)
OPERATE
2 Turn off the MAIN POWER switch
after the STAND BY indicator
changes to steady on.
OFF [‡ ‡ ‡ ‡ ‡ ]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). Turn it
off after the STAND BY indicator becomes on (stand-
by mode).
Projector's indicator
STAND BY
(ON)
Projector
(ON)
or
OPERATE
Projector
(Blinking)
\
STAND BY
Projector
(OFF)
STAND BY