Basic Operations; Turning On The Power - JVC DLA-M5000LE Manuel D'instructions

Basic Operations

I Projector's buttons
STAND BY indicator
OPERATE indicator
STAND BY OPERATE
OPERATE button
1
MAIN POWER switch
I Remote control unit
QUICK
ALIGN. OPERATE
AV HIDE
PRESET PAGE BACK
AV RGB/COMPUTER
+
U T
SHIFT ZOOM FOCUS
–
D W
LENS
I Caution on extended projection:
When projection continues for an extended amount of
time, be sure to allow the lamp to be turned off for at
least two minutes for every 72 hours of continued
projection.
If you do otherwise, the service life of the lamp may be
severely affected.
24
TEMP
LAMP EMERGENCY AV RGB
2 1
,
2
,
2 1
OPERATE button ,
The following describes the basic procedure for normal use
of the projector.

1. Turning on the Power

1 Turn on the MAIN POWER switch of the
projector.
ON [ ❙ ]: The main power turns on and the STAND BY
indicator comes on.
2 Press the OPERATE button for one second
or more.
(Or press the remote control's OPERATE
button for one second or more.)
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Remote control unit
OPERATE
Note
• After the power is turned on, the screen may be jumbled for
a few seconds, but this is not a malfunction.
I Turning off the Power
1 Press the OPERATE button for one second
or more.
(Or press the remote control's OPERATE
button for one second or more.)
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
Example of the
projector's button
OPERATE
2 Turn off the MAIN POWER switch after the
cooling fans have stopped running.
OFF [‡ ‡ ‡ ‡ ]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). About
10 minutes after the STAND BY indicator comes on
steady (stand-by mode), the cooling fans (except the
one for the light-source lamp power supply) will stop,
and then turn off the MAIN POWER switch.
Projector's indicator
STAND BY
Projector
or
OPERATE
Projector
\
STAND BY
Projector
STAND BY