Connecting The Power Cord (Supplied) - JVC DLA-M5000LE Manuel D'instructions

Connecting to Various Devices

Connecting the Power Cord (Supplied)

After all devices have finished being connected, connect the projector's power cord. At this time, do not turn on the MAIN
POWER switch yet.
I Preparation
Attach a plug which matches your wall outlet, to the power
cord. For how to attach a plug, consult your dealer or a
local service center.
1 Insert the supplied power cord into the
power input terminal (AV IN ~) of the
projector.
1. Remove the power input terminal cover.
The cover is a screwed type. Turn the cover in the
direction of the arrow to remove.
2. Insert the projector plug of the supplied power
cord into the power input terminal of the projector.
Align the groove on the projector plug of the power
cord with the claw on the power input terminal of the
projector, and push the plug in firmly.
After that, turn the ring on the plug in the direction of
the arrow to fix.
2 Insert the plug of the supplied power cord
into a wall outlet.
CAUTIONS
• Since the power requirement of the projector is high, be
sure to insert the power plug directly into a wall outlet.
• This projector requires a single phase, 3-wire, 200V ~ 240V
wall outlet.
22
I To use the projector
• Remove the lens cap.
CAUTION
• Be sure to remove the cap; otherwise, it may be deformed
(or degraded in quality) or melted, possibly causing a fire or
malfunction.
Lens cap
CAUTIONS
To prevent fire and electric shock, observe the
following:
• When you do not use devices, pull out their power cords
from wall outlets.
• Do not connect the devices with power cords other than
supplied.
• Do not use voltage other than the power voltage indicated.
• Do not scar, damage, or work on the power cords. Also, do
not put a heavy object on, heat or pull the power cords,
otherwise they may be damaged.
• Do not insert or pull out the plugs with a wet hand.