Displaying A Still Picture (Freeze); Zooming A Part Of The Image (Digital Zoom +/-) - JVC DLA-M2000LU Manuel D'instructions

(QJB'/$0ERRN 3DJH  7KXUVGD\ $XJXVW     $0
Basic Operations
I Remote control unit
FREEZE
button
PRESET
button
ESCAPE
button
DIGITAL ZOOM
+/-button
SHUTER
FREEZE message
FREEZE inhibit message
DIGITAL ZOOM inhibit message
36
FREEZE OPERATE
HIDE
PRESET MENU
Cursor
(5/∞/2/3)/
ENTER button
ESCAPE VIC SELECT
PC
+
DIGITAL
ZOOM KEYSTONE VIDEO
–
+
T
U
ZOOM FOCUS
SHIFT
D W –
+ +
QUICK
ALIGN. VOLUME
– –
RM-M2000 REMOTE CONTROL UNIT
FREEZE
FREEZE
D.ZOOM
DLA-M2000LU/M2000SCU/ LCT0940-002A / ENGLISH

Displaying a Still Picture (FREEZE)

While projecting an image, a still picture is obtained at any
time by using the FREEZE button on the remote control.
When you press the FREEZE button:
"FREEZE" appears on the screen for a few seconds and
then the still picture is shown on the screen. Refer to the
FREEZE message shown on the left of this page.
* To forcibly clear "FREEZE", press the ESCAPE button.
When you press the FREEZE button again.
The original image resumes.
Remote control unit
FREEZE
Notes
• During freezing, the picture sent from the signal source is lost.
• If any of the inoperative buttons ("MENU", "QUICK ALIGN.",
"KEYSTONE") are pressed while displaying a still picture,
"FREEZE" is displayed on the screen.
• This function will not work with some signal sources
(UXGA, etc). In this case, the FREEZE inhibit message
appears for a few seconds, as shown on the left. To forcibly
clear this message, press the ESCAPE button.
Zooming a Part of the Image (DIGITAL
ZOOM +/–)
A part of the image being projected can be digitally magnified up
to four times. When the DIGITAL ZOOM + or – button is
pressed, "Digital zoom" appears on the screen together with the
level bar and magnifying power (×1.0, ×1.2, ×1.4, ×1.6, ×2.0,
×2.5, ×3.2, ×4.0). When "15 sec." is displayed in the menu,
"Digital zoom" will appear in approximately 15 seconds.
Digital zoom 1.2
• To zoom up or zoom down, press the DIGITAL ZOOM + or
– button on the remote control.
Remote control unit
+
DIGITAL
ZOOM
–
Moving the zoomed image:
While "Digital zoom" appears on the screen, you can move
the zoomed image with the cursor (5/∞/2/3)/ENTER button
on the remote control.
5: Upper part of the image will be
displayed.
∞: Lower part of the image will be
displayed.
2: Left side part of the image will
be displayed.
3: Right side part of the image
will be displayed.
Notes
• This function will not work with some signal sources
(UXGA, etc). In this case, the DIGITAL ZOOM inhibit
message appears for a few seconds, as shown on the left.
To forcibly clear this message, press the ESCAPE button.
• The quality of the zoomed image reduces in comparison
with the original one.
• To return to the original size (×1.0) and original position,
press the PRESET button while "Digital zoom" is displayed
on the screen.