Bottom Surface - JVC DLA-M2000LU Manuel D'instructions

(QJB'/$0ERRN 3DJH  7KXUVGD\ $XJXVW     $0
Controls and Features

Bottom Surface

y
Air inlet (filter)
Air is taken in through the filter to cool the light-source
lamp. If the filter is blocked or if something that obstructs
the flow of air is placed around the projector, heat may
build up inside and could cause a fire. For required
space, refer to "Precautions for Installation" on page 15.
CAUTIONS
• Be careful as paper, cloth or soft cushion could be drawn in
if placed nearby. Do not block the filter, or heat may build
up and could cause a fire.
• Clean the filter periodically. For details, refer to "Cleaning
and Replacing the Filter Cover" on page 60. Deposition of
dirt on the filter reduces the cooling effect, causing heat to
build up inside, which could cause a fire or malfunction.
u
Opening for replacing the light-source lamp
For replacing the light-source lamp, refer to "Replacing
the Light-Source Lamp" on page 56.
i
Fixing foot
o
Position selecting screw for ceiling mounting
When using the projector in an upside-down, ceiling-
mounted position (inverted top-to-bottom and right-to-
left), the "position selecting screw for ceiling mounting"
must be turned to switch to ceiling mounting.
This will correct variance in color images (shading),
which otherwise would occur in ceiling mounting.
For more information, refer to "Setting the Position
Selecting Screw for Ceiling Mounting" on page 21.
CAUTION
• To ceiling-mount and adjust the projector, special expertise
and technique are necessary. Be sure to ask your dealer or
specialist to perform this work.
8
DLA-M2000LU/M2000SCU/ LCT0940-002A / ENGLISH
o
y
u
i