Service Information - DeWalt DWFP55126 Guide D'utilisation

Masquer les pouces Voir aussi pour DWFP55126:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

Service Information

Please have the following information available for all
service calls:
Model Number _______________________________
Serial Number ________________________________
Date and Place of Purchase _______________________
To Replace Regulator (Fig. A, E)
1. Release all air pressure from air tank. See To Drain Tank
 
in the Maintenance
section.
2. Unplug unit.
3. Remove the console cover.
4. Using an adjustable wrench, remove the safety valve 
from the regulator manifold 
5. Remove the hose by removing the hose clamp 
nOTE: The hose clamp is not reusable. You must
purchase a new hose clamp.
Fig. E
12
6. Remove three pump mounting screws securing pump.
7. Carefully lift pump up away from brackets and out of
the way.
8. Using an adjustable wrench remove the regulator
knob
.
9. Apply pipe sealant to new regulator manifold and
assemble, tighten with wrench.
10. Reapply pipe sealant to safety valve.
11. Reassemble all components in reverse order of removal.
Make sure to orient gauges to read correctly and use
wrenches to tighten all components.
Storage
Before you store the air compressor, make sure you do
the following:
1. Review the Maintenance section on the preceding
pages and perform scheduled maintenance
as necessary.
2. Drain water from air tank. See To Drain Tank
under Maintenance.

WARNING: Risk of Bursting. Water will condense
in the air tank. If not drained, water will corrode
and weaken the air tank causing a risk of air
tank rupture.
3. Protect the electrical cord and air hose from damage
(such as being stepped on or run over). Wind air hose
loosely around the compressor handle. Wrap electrical
cord onto the cord wrap.
4. Store the air compressor in a clean and dry location.
8
7
11 
.
 12 
.
Accessories

WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Register Online
Thank you for your purchase. Register your product now for:
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D
WALT will repair, without charge, any defects due to
e
faulty materials or workmanship for three years from
the date of purchase. This warranty does not cover
part failure due to normal wear or tool abuse. For
further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
(1-800-433-9258). This warranty does not apply to
accessories or damage caused where repairs have been
made or attempted by others. THIS LIMITED WARRANTY
IS GIVEN IN LIEU OF ALL OTHERS, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, AND EXCLUDES ALL INCIDENTAL
OR CONSEQUENTIAL DAMAGES. Some states do not allow
limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
by our:
1 YEAR FREE sERViCE
D
WALT will maintain the tool and replace worn parts
e
caused by normal use, for free, any time during the first year
after purchase.
90 DAY MOnEY BACK gUARAnTEE
If you are not completely satisfied with the performance of
your D
WALT Power Tool, Laser, or Nailer for any reason, you
e
WALT
e
WALT Industrial
e
WALT
e
WALT tools are covered
e

Publicité

Table des Matières
loading

Table des Matières