Dometic SINEPOWER DSP 1212C Instructions De Montage Et De Service page 19

SinePower
• Keep to the specified cable cross section and fit a cable fuse (fig. 8 1, page 1) as
close to the battery as possible on the positive cable (see the table).
Device
DSP1212C
DSP1224C
DSP2012C
DSP2024C
9.2 Connecting the device
!
WARNING!
Before connecting the AC output cable, make sure the device is
switched off at the main switch.
A
NOTICE!
Make sure that you do not reverse the polarity. Incorrect polarity can
damage the device.
I
NOTE
Tighten the nuts and bolts to a maximum torque of 15 Nm. Loose
connections may cause overheating.
➤ Connect the device as shown:
– Connecting the battery: fig. 7 and fig. 8
– Connecting the ground terminal fig. 9
– Connecting the 230 V power cable: fig. 0
– Connecting the 230 V output cable: fig. 0
9.3 Connecting the DSP-EM
A
NOTICE!
Only plug in the connection to the DSP-EM in the remote port. The
device can be damaged by connecting it incorrectly.
➤ Connect the DSP-EM as shown (fig. a).
EN
Required cable
cross section
25 mm²
16 mm²
50 mm²
25 mm²
Connecting the device
Cable fuse
>200 A
>100 A
>400 A
>200 A
17