Dometic SINEPOWER DSP 1212C Instructions De Montage Et De Service page 13

SinePower
The device is operated in the following network configuration:
• TN network (fig. i):
The neutral conductor of the AC output is grounded. A safety switch (RCD)
must be installed at the device's AC output.
The softstart function allows the connection of loads with high starting current.
The device can be easily controlled using the DSP-EM.
7.1 Control elements device
Item in
Description
fig. 2
1 Main switch
"ON/OFF/REMO."
2 Status LED
3 Breaker
7.2 Connections
Item in
Description
fig. 2
4 AC PG fitting
5 AC PG fitting
6 Ground terminal (Earthing on the vehicle bodywork)
7 Positive terminal
8 Negative terminal
9 CI/LIN BUS connections (LNA)
Battery sensor or temperature sensor connection
10 DSP-EM connection (LNB)
11 Connection of remote switch
12 Fan
EN
Explanation
Switches the device on, off or to operation via
a remote control(accessory)
See chapter "Status indications" on page 21
Protects the device from overload.
The fuse can be pressed in again once it has
triggered.
Technical description
11