Abbott ALERE AFINION AS100 Manuel D'utilisation page 35

Menu Touch button
Operator ID
configuration
Regional settings
Screen/Beeper
menu
Date/Time menu
General settings
menu
QC lockout
menu
Operator list
QC lockout
QC lockout
interval
Name Function
Decrease Decrease contrast/volume.
Scroll up View previous.
Scroll down View next.
Exit Exit current menu and return to previous screen view.
Accept Accept (a setting or a test result).
Abort Abort the test result or cancel operation.
Add button Add new operator or control lot.
Delete button Delete operator or control lot.
Edit button Edit QC lockout interval or operator ID.
Operator ID disabled Operator ID function is disabled.
Operator ID is required to be entered to run an Afinion Test
Operator ID enabled
Cartridge.
Operator ID is required to be entered to run an Afinion Test
Operator ID enabled
Cartridge. The operator ID is verified against the
with verification
instrument operator list.
Language Enter language configuration.
Select HbA1c units. The default HbA1c unit setting is %.
HbA1c configuration
Other units are available.
Select ACR units. The default ACR unit setting is mg/mmol.
ACR configuration
Other units are available.
Lipid Panel Select Lipid Panel units and tests. The default Lipid Panel unit
configuration setting is mmol/L. Other units are available.
Screen contrast Enter screen contrast setting.
Screen alignment Enter screen alignment function.
Beeper volume Enter beeper volume setting.
Date Enter date setting.
Time Enter time setting.
Erase Erase all content and configurations.
QC lockout Enable/disable QC lockout function.
QC lockout interval Configure QC warning and lockout interval.
Control lot
View, add or delete control lots stored on instrument.
information
Operator list export Export operator list from instrument to USB flash.
Operator list import Import operator list from USB flash to instrument.
QC lockout disabled QC lockout is disabled for this test.
One passed control run of either C I or C II is required to reset
QC lockout enabled
QC lockout interval.
Two passed control runs, C I and C II is required to reset
QC lockout enabled
QC lockout interval.
Interval by number of QC reminder and lockout active after a configured set of
patient tests patient tests.
Interval by number of QC reminder and lockout active after a configured set of
hours hours.
Gallery of Icons
EN | 33