Abbott ALERE AFINION AS100 Manuel D'utilisation page 24

Testing Procedures
Using the operator ID function
Entering operator ID
If enabled, the operator's identification (ID) is required before processing an Afinion Test Cartridge (see "Operator
Configuration" page 14).
Both letters and numbers can be entered (maximum 16 characters). The operator ID will be displayed with the result and stored along
with the other specific data for this run (see "Patient and control results records", page 26).
If configured to "enabled with verification" the operator ID entered is required to be present in the operator ID list (see "Operator
configuration" page 14).
Enter the operator ID by numbers and/or touch
Analyzer, a bar-coded operator ID can be entered.
Touch
The operator will be automatically logged out according to the configuration (see "Operator configuration" page 14).
The operator may also manually logout by using the operator logout button
Using the patient ID function
The patient ID function is enabled as a default setting. As long as this function is enabled, the patient ID must be entered for each
patient sample to be analyzed. The patient ID function can be disabled (see "Patient ID configuration", page 13).
Entering patient ID
It is recommended to enter the patient ID during processing of the Test Cartridge in the Analyzer. Entering the patient ID will not
interrupt the processing. It is also possible to enter the patient ID before the processing.
1
Touch
2
It is possible to enter up to four patient ID entries for each patient, P-ID 1 to 4. When enabled, P-ID 1 is
required to be entered. Scrolling between the patient IDs is done with the
Enter patient ID by numbers and/or touch
If a barcode reader is connected to the Analyzer, a barcoded patient ID can be entered.
Touch
3
The entered P-ID 1 will appear on the screen.
The patient ID touch button will remain in the view and it is possible to make corrections.
The P-ID 1 will be stored in the memory and displayed along with the other specific data for this run (see "Patient ID configuration"
page 13). Patient ID 2-4 will not be displayed in the result records but will be stored in the memory and appear on printouts and data
transferred to data management systems.
22 | EN
to confirm and return to previous view.
to enter the patient ID option.
to confirm and return to previous view.
to enter letters. If a barcode reader is connected to the
displayed in the Start-up menu.
to enter letters (maximum 16 characters).
and .