Troubleshooting Guide - Waterpik WP-250 Mode D'emploi

16

TROUBLESHOOTING GUIDE

PROBLEM
Tips
Leakage between the tip and handle knob.
Pik Pocket Tip
TM
Tear in soft tip.
Water Flosser Base
Hose to the handle leaks.
Unit doesn't start.
CAUSE
1) Tip not fully engaged.
1) Tip is worn.
2) Tip is split.
1) Missing black reservoir valve.
2) Black reservoir valve is upside down.
2) Tip is clogged with debris.
3) Black reservoir valve is clogged.
4) Hard water deposits.
1) Motor not running.
CORRECTIVE ACTION
which can be found at www.waterpik.com/intl, for a self service
repair kit.
which can be found at www.waterpik.com/intl, for
a replacement reservoir.
2) Ensure valve is right-side up (see image to right).
2) Flush tip under faucet or replace tip.
under warm running water and place back into reservoir.
Ensure the valve is right-side up (see above image).
water. Set pressure control dial to high, point the handle and tip
by repeating with a full reservoir of clean warm water.
1) Be sure outlet is functioning; test with another appliance
(check electrical reset button and/or wall switch).