Festo CPASC-DN Guide Rapide page 24

Fitting a new node
1
2
1.
Insert the plug of the ribbon cable.
Place the field bus node on the terminal so that shoulder 1
2.
comes to rest in the groove 2. (viewed from below)
3.
Push the field bus node in the direction of the valves, so
that the plastic nose 3 fits completely into the recess.
4.
Screw in screws with spacers (position see Dismantling)
and tighten with 0.1 Nm (±10%).
24
Contact plate
The contact plate must not be
bent when the node is fitted.
2
Festo CPASC−DN 0412a English
3
.