Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
03/2014
1006322-01
4.9
Instructions for replacing the lamps
The UV effect of the lamps and thus the tanning effect decreases over the
course of time. Therefore, the replacement intervals specified in the mainte-
nance plan must be adhered to.
UV filters are utilized in order to control the UV radiation, e .g. the filter panels
on the facial tanner. However, the filter effect decreases over the course of
time. Therefore, the replacement intervals specified in the maintenance plan
must be adhered to.
4.9.1
Low pressure lamps
WARNING!
Danger of burns from hot lamps and device parts.
If the tanning device was operated before being switched off
and opened, lamps and housing parts may be hot.
–
Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled down
sufficiently.
Replace faulty UV low pressure lamps immediately.
Always replace the entire set of lamps after the specified operating
time.
–
Turn 90° and carefully remove from the socket.
–
UV low pressure lamps possess a reflector which directs the light out-
wards. The lamps must be mounted in such a way that the rear side of
the reflector is located on the device side.
Cleaning and maintenance
Operating instructions – 25/46
Publicité
Chapitres
Table des Matières
