Pre-Filter (Only Ua-Kil80E) - Sharp UA-KIL80E Manuel

PRE-FILTER PRE-FILTER
1. Remove the Back Panel and the
Dust Box.
2. Remove the Pre-Filter Lock.
Pre-Filter Lock
1
1
2
3. Remove the Shaft.
Shaft (upper)
Shaft (lower)
4. Remove the Cap and pull out the
Pre-Filter from the Shaft.
1
Cap
Pre-Filter
Shaft
(Only UA-KIL80E) (Only UA-KIL80E)
Tab (orange)
3
4
1
2
①
2
2
1
EN-18
5. Soaking and cleaning the Pre-Filter.
1. Add a small amount
of kitchen detergent
to water and soak for
about 10 minutes.
2. Rinse off the kitchen
detergent with clean
water.
3. Dry it thoroughly.
NOTE
• Do not clean it too hard. Do not wash it with a
washing machine. (Otherwise it might cause
damage.)
• Do not dry it with a dryer. (Otherwise it might
cause shrinkage.)
6. Insert the Pre-Filter shaft into the
groove of the Shaft.
2
7. Attach the Shaft (upper) to the Back
Panel.
1
2
8. Roll up the Pre-Filter.
Pre-Filter
1
1
2
Shaft (upper)
Click, Click, ...
Pre-Filter
Shaft (lower)