Sensors; Hepa Filter / Deodorizing Filter; Back Panel With Pre-Filter; Only Ua-Kil60E) - Sharp UA-KIL80E Manuel

SENSORS

Remove the
dust gently
with a cleaning
tool such as a
vacuum cleaner.
NOTE
How to clean hard to remove dirt.
Sensor Filter
1. Remove the Unit Cover.
2. Remove the Sensor Filter.
3. If the Sensor Filter is very dirty, wash it with water
and dry it thoroughly.
HEPA FILTER /
DEODORIZING FILTER
Remove the dust on the filters.
HEPA Filter
Tag
Deodorizing Filter
NOTE
• Do not wash the filters. Do not expose to
sunlight.
(Otherwise these filters may lose efficacy.)
• Some odours absorbed by the filters will break
down over time, causing additional odours.
Depending on usage conditions, and especially if
the product is used in environments significantly
more severe than a normal household, these
odours may become noticeable sooner than
expected.
Replace the filter in those cases or if dust is unable
to be removed after maintenance.
Sensors
Clean only the tagged
surface. Do not clean
up the opposite
surface. The filter is
fragile, so be careful
not to give too much
pressure.
Both surfaces can
be cleaned. The filter
may be broken if being
too much pressure is
applied on it, so please
handle it with care.
BACK PANEL
WITH PRE-FILTER

(Only UA-KIL60E)

Remove the
dust gently
with a cleaning
tool such as a
vacuum cleaner.
NOTE
• Do not apply excessive pressure when
scrubbing the Back Panel.
• How to clean hard to remove dirt.
1. Add a small amount of kitchen detergent to water
and soak for about 10 minutes.
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the filter in a wellventilated area.
BACK PANEL
(Only UA-KIL80E)
Remove the
dust gently
with a cleaning
tool such as a
vacuum cleaner.
EN-16
Back Panel
(Pre-Filter)
Back Panel
Back Panel