Operation - Sharp UA-KIL80E Manuel

OPERATION

START/STOP
START
♪
NOTE
• When the product starts operation, the
operation starts in the previous mode it was
operated in.
AUTO MODE
The fan speed is automatically controlled
depending on the six detection. (PM2.5 / Usual dust
/ Odour / Temperature / Humidity / Light)
PLASMACLUSTER
ION SPOT MODE
Use this mode when you want to remove adhering
odour, germs, and other substances from clothes,
sofas and curtains.
Discharges stronger air with high-density
Plasmacluster ions only in the forward direction.
♪
Adjust Front Louver manually.
NOTE
• The Plasmacluster ion cannot be turned
"OFF".
STOP
♪
～
♪
EN-10
SELECT AIR VOLUME
AND MODE
♪ ♪ ♪
POLLEN SLEEP LOW
POLLEN:
The Sensitive Dust Sensor sensitivity is
automatically increased and quickly detects
impurities such as dust and pollen and clean the air
powerfully.
SLEEP:
The product will operate quietly, and the fan speed
is automatically switched depending on the amount
of impurities in the air.
When the Light Control is set to "Auto", Front
Display and Cleanliness Indicator automatically go
off. (Page 12, 13)
HUMIDIFICATION
SETTING
ON
♪
NOTE
• When operating with humidifi cation ON in
the modes in the table below, the product
automatically controls humidity by sensing
temperature and humidity. (Except MAX / MED
/ LOW mode.)
Temperature
(Except MAX / MED /
LOW / SLEEP)
- 18 ºC
18 ºC - 24 ºC
24 ºC - 28 ºC
28 ºC -
♪ ♪ ♪
MED MAX
OFF
♪ ♪
Humidity
ALL MODE
SLEEP
MODE
65 % 65 %
60 % 65 %
55 % 60 %
45 % 50 %