Tools You Will Need; Materials You May Need - GE Appliances Cafe CFE Serie Manuel D'utilisation Et D'installation

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
Anti-Tip Floor Bracket Installation (Models PYE, CYE, GYE, PWE, CWE, and ZWE only)
WARNING
especially with any doors open. These models must
be secured with the anti-tip floor bracket to prevent
tipping forward, which could result in death or
serious injury. Read and follow the entire installation
instructions for installing the anti-tip floor bracket
packed with your refrigerator.
NOTE:
GEAppliances.com.

MATERIALS YOU MAY NEED

Lag Bolts
MEASURE CABINET
AT-1
OPENING AVAILABLE VS.
REFRIGERATOR WIDTH
Measure width of cabinet opening where
refrigerator will be placed, W.
Be sure to account for any countertop overhang,
baseboard thickness and any clearance desired.
in the middle of this opening.
Rear Wall
W
32
Tip Over Hazard.
Anchor Sleeves
Baseboard
Thickness or
Countertop
Overhang
Clearance
RH Side

TOOLS YOU WILL NEED

Pencil
LOCATING THE ANTI-TIP
AT-2
FLOOR BRACKET
A
Place the anti-tip floor bracket locator template
up against the rear wall, within W, and in line
with the desired location of the RH side of the
B Place the anti-tip floor bracket onto the locator
template with its RH floor holes lined up with
the floor holes indicated on the template sheet,
of the sheet or the RH side of the refrigerator.
C Hold down in position and use the anti-tip floor
bracket as a template for marking the holes
based upon your configuration and type of
construction as shown in Step 3. Mark the hole
locations with a pencil, nail or awl.
NOTE:
mount the floor bracket (one on each side of
all the acceptable mounting configurations for
floor bracket for your configuration.
Tape measure
2 Wall Holes
RH Holes
Rear RH
Corner of
Cabinet Wall
RH Side of
Locator
Refrigerator
Template Sheet
49-60791-2