Reversing The Door Swing; Tools You Will Need - GE GTH18DBRRCC Manuel D'utilisation Et D'installation

PLUG IN THE REFRIGERATOR
11
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.

REVERSING THE DOOR SWING

IMPORTANT NOTES
When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side—if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
Installation Instructions
19
START THE ICEMAKER
On power switch models, set the icemaker power
switch to the l (on) position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below.
It will then begin operation automatically.
Power
switch
Power switch model
Feeler arm model
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.

TOOLS YOU WILL NEED

Phillips screwdriver
Masking tape
T20 or T25 Torx ®
driver, whichever your
model requires
Feeler Arm in the
STOP (up) position
Feeler Arm in
the ON (down) position
3/8" Head socket driver
(a 6-point socket is
recommended)
Putty knife or
thin-blade screwdriver