Arcam Solo movie Manuel page 37

Problem Check that...
There is radio or television reception where the interference is coming from.
<
interference Switch off each source component in
turn, then any other equipment. Most
electronic equipment does generate low
levels of interference.
try re-arranging cabling from the
<
nuisance source away from other
cabling.
ensure that the cabling used is high
<
quality, specified for its purpose, and is
properly screened.
if the problem persists, contact your
<
dealer.
The source switching changes randomly < there are no static or impulse
or freezes on one source interference problems caused by
nearby power equipment switching,
e.g., heating or air conditioning
control. Switch the Solo off, wait ten
seconds, then switch it on again to
clear an operating problem. Contact
your installer if the problem returns or
persists.
there is no direct sunlight shining on the
<
infra-red detector behind the front panel
display.
When a USB memory device is a USB memory device is connected that
<
connected, 'USB' is not shown in the conforms to the mass storage class.
network client's list of folders < a USB hub is not being used.
If files on a USB memory device cannot the USB device is formatted in FAT16 or
<
be played: FAT32.
< the USB device does not have multiple
partitions.
the files are in a compatible format.
<
If files on a computer cannot be played
< the files are in a compatible format.
the computer is connected via a network
<
and not USB – the Solo USB port cannot
be used for a direct connection to a
computer
Problem Check that...
If you cannot connect to a wired the Ethernet cable you are using is
<
network correctly connected between the Solo
and the network hardware.
the network is set up for fixed IP
<
addressing and you have the Solo set to
use DHCP.
< the network is set up for DHCP and
you have the Solo set to use fixed IP
addressing.
USB firmware update
The firmware in your Solo can be updated from a USB flash drive containing firmware
update files. You can download the latest firmware file, together with upgrading
instructions, from the Arcam website (www.arcam.co.uk)
E-35