Remote Control E; Using The Remote Control; Inserting Batteries Into The Remote Control - Arcam Solo movie Manuel

remote control
The Solo universal remote
control
The Solo remote is a sophisticated
'universal' backlit remote control that
can control up to eight devices. It is pre-
programmed for use with the Solo and
with its extensive built-in library of codes,
it can also be used with thousands of third
party audio-visual components, such as
TVs, satellite receivers, set-top boxes, PVRs,
etc.
The Solo remote is a 'learning' remote, so
you can teach it almost any function from
an old single-device remote.
Inserting batteries into the remote
control
<
<
<

Using the remote control

Please keep in mind the following when
using the remote control:
Ensure there are no obstacles
<
between the remote control and
the remote sensor on the Solo. The
remote has a range of about 7 metres.
(If the remote sensor is obscured, the
IR remote control input jack on the
rear panel is available. Please consult
your dealer for further information.)
Remote operation may become
<
unreliable if strong sunlight or
fluorescent light is shining on the
remote sensor of the Solo.
Replace the batteries when you notice
<
a reduction in the operating range of
the remote control.
Open the battery compartment on
the back of the handset, by removing
its cover.
Insert two 'AAA' batteries, as indicated
in the battery compartment.
Place the battery compartment cover
back firmly into its locked position
with a click.
NOTE
Incorrect use of batteries can result
<
in hazards such as leakage and
bursting.
Do not mix old and new batteries
<
together.
Do not use non-identical batteries
<
together – although they may look
similar, different batteries may have
different voltages.
Ensure the plus (+) and minus (-)
<
ends of each battery match the
direction indicated in the battery
compartment.
Remove batteries from equipment
<
that is not going to be used for a
month or more.
When disposing of used batteries,
<
please comply with governmental
or local regulations that apply in
your country or area.
E-18
The Solo remote complies with
Part 15 of the FCC rules
This equipment has been tested and
found to comply with the limits for
a class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide a reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses, and can
radiated radio frequency energy and if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
< Reorient or relocate the receiving
antenna.
< Increase the separation between the
equipment and receiver.
< Connect the equipment into an
outlet or a circuit different from that
to which the receiver is connected.
Consult the dealer or an
<
experienced radio/TV technician
for help.