Arcam Solo movie Manuel page 31

Settings Menu
Display
OK
E
Display TV System
TV System [select option]
D
B C
E
Display Resolution
Resolution [select option]
D
B C
E
Display HDMI Colourspace
HDMI Colourspace [select option]
D
Display settings diagram applies to
Audio
Audio DRC – Selects the Audio Dynamic
Range Control mode to 'Off' , 'On' . or 'Auto'
Dynamic Range is the range between the
loudest sounds and the quietest ones. If
set to 'On' you can listen to a movie at a
lower volume without losing sound clarity.
B
NTSC
< Off – No dynamic range compression
C
PAL On – Dynamic range compression
<
Auto – DRC is selected by the source
<
Auto
material
Speaker Setting – sets the number of
speakers and the level, distance and size.
Auto
You can select:
4K2K
< 2 Channels – L (Left), R (Right)
B
1080p
3 Channels – L (Left), C (Centre), R
<
C 1080i
(Right)
4 Channels – L (Left), R (Right), LS
720p <
(Left Surround), RS (Right Surround)
480p/576p
5 Channels – L (Left), R (Right), C
<
480i/576i
Centre), LS (Left Surround), RS (Right
Surround)
Please refer to the "speakers" on page E-15
B
Auto
for speaker naming and placement.
C
YCbCr
For each of the speaker configuration you
YCbCr422
can set the following:
Full RGB Subwoofer presence (On or Off). If
<
the subwoofer presence is set to On,
RGB
then the following subwoofer settings
xvYCC
can be adjusted: level, distance and
crossover
E-29
Size - Large (capable of full frequence material is used to obtain best results.
<
range reproduction) or Small (not
<
capable of full frequency range
reproduction at the low frequency
end). Note that most of the home
<
cinema speakers are small.
< Level - calibration settings for the
test noise signal level through the
loudspeakers and measured at the
listening position SACD Priority – Selects the SACD track
Distance - calibration settings for the used. (Solo movie only). You can select:
<
distances between the loudspeakers
<
and the listening position
<
< Crossover - set the frequency at which
the Solo starts to redirect bass signals Subwoofer – Specify whether or not a
to the subwoofer subwoofer is connected to the unit. If the
subwoofer presence is set to On, then
Prologic II the following subwoofer settings can be
Dolby Pro Logic II decoding is designed to adjusted:
produce five-channel output from two-
<
channel source material.
There are three different options available
for this setting: Off, Movie or Music. The
Movie and Music modes are intended <
for use as their names suggest. Due to
the different recording methods used for
movies and music it is recommended that
the correct decoding mode for your source
Settings Menu
Audio
OK
E
Audio Subwoofer Out
Subwoofer Out [select option]
D
Audio settings diagram applies to
Movie mode: This mode provide a
surround sound effect from a stereo
input.
Music mode: This mode is similar
to the movie mode, but with less
emphasis on the surround channels,
in order to preserve the original stereo
image.
Multi-ch – Multi-channel track
2-ch – Stereo track
Level - calibration settings for the
test noise signal level through the
loudspeakers and measured at the
listening position
Crossover - set the frequency at which
the Solo starts to redirect bass signals
to the subwoofer
B
Off
C
On