Operation And Use - Beem Fresh-Aroma-Perfect V2 Mode D'emploi

Fresh-Aroma-Perfect V2

Operation and use

Switching on the display lighting
The blue display lighting goes out 60 sec-
onds after the last keypress except when
the appliance is in operation, e.g. coffee is
being brewed or kept warm.
Press any key to switch on the display
lighting.
NOTE
► Only press the button for the desired
action after the lighting goes on.
Setting the time
Insert the plug into the mains socket.
The time 12:00 starts flashing on the
display.
Set the hour by pressing the
ton (32).
Set the minutes by pressing the
button (33).
NOTE
► The time will be stored until either
a new time is entered or the plug is
removed from the socket for more
than a minute.
Filling with water
(image A1)
Open the water tank lid (3).
Only fill the amount of water required
for the desired number of cups.
Close the water tank lid (3).
24
NOTE
► The entire amount of water in the
tank is always used, independent of
the number of cups or the strength of
coffee set.
► Pay attention to the filling level indica-
tor (12) in the water tank. Do not
overfill!
Filling with coffee beans
Take the lid off the coffee bean com-
partment (1).
Make sure that the water tank lid (3)
is closed to prevent coffee beans from
falling into the water tank.
Fill the coffee bean compartment (2)
with coffee beans. Do not overfill!
Put the lid (1) back onto the coffee
bean compartment (2).
but-
Inserting a new filter bag
Press the release button (5) to open
the filter compartment (10).
Place a size 4 filter bag into the filter
insert (11).
Close the filter compartment (10).
Setting the number of cups
Press the
until the desired number of cups ap-
pears in the display.
The following settings are possible:
2, 4, 6, 8, or 10 cups.
BEEM - Elements of Lifestyle
EN
button (29) repeatedly
2 - 10