Connecting A Device; External Devices - JVC KD-ADV7490 Manuel D'instructions

2
Select a number or blank space.
3 1
Repeat steps and
entering a PIN code.
4
Confirm the entry.
"Open..." flashes on the display.
6
Use the Bluetooth device to search and
connect.
On the device to be connected, enter the same
PIN code you have just entered for this unit.
"Connected (and device name)" appears on the
display.
Now connection is established and you can use the
device through the unit.
The device remains registered even after you
disconnect the device. Use "Connect" (or activate
"Auto Connect") to connect the same device from
next time on. (See the following and page 51.)

Connecting a device

Perform steps 1 – 3 on page 26, then...
1
• Select "Search" to search for available
devices.
The unit searches and displays the list of the
available devices.
If no available device is detected, "Device not
found" appears.
• Select "Special" to connect a special device.
The unit displays the list of the preset devices.
2
until you finish
2
Select a device you want to connect.
3
• For available devices...
1
Enter the specific PIN code of the device to
the unit.
Refer to the instructions supplied with the
device to check the PIN code.
2
Use the Bluetooth device to connect.
Now connection is established and you can
use the device through the unit.
• For special device...
Use "Open" or "Search" to connect.
Connecting/disconnecting/deleting a
registered device
1
Select "BT-PHONE" or "BT-AUDIO."
2
Select a registered device you want to
connect/disconnect/delete.
3
Enter setting menu.
4
• Select "Connect" or "Disconnect" to
connect/disconnect the selected device.

EXTERNAL DEVICES

Continued on the next page
27