Unpacking; Setup And Installation - Daikin AHT KALEA GM FR Traduction De La Notice Originale

7 | Unpacking

7 Unpacking
Responsibility
– Qualified staff
a) Check the appliance for damage before and during
unpacking.
b) In the event of damage to the appliance, promptly
contact the maintenance service
[see } Chapter 12.5].
WARNING
Dispose of packaging material and
film.
Suffocation hazard.
§ Keep packaging material and film away
from children.
§ Do not allow children to play with pack-
aging material or film.
CAUTION
Sharp edges of the appliance. Heavy
appliance parts.
Cutting injuries to the hands. Hands may be-
come trapped.
§ Great care should be afforded to fingers
and hands.
§ Wear protective gloves.
NOTICE
Material and property damage due to missing
parts in the appliance.
§ Check the packaging for loose parts.
§ Do not dispose of loose parts; clarify their use with
the maintenance service [see } Chapter 12.5].
8

Setup and installation

Responsibility
– Qualified staff
WARNING
Damage to the refrigerant circuit.
Flammable refrigerant can escape and cause
an explosive gas/air mixture. Fire hazard.
§ Do not obstruct the ventilation openings in
the appliance housing. Use only original
accessory parts.
§ Only install the appliance in well-ventilated
rooms.
§ If the appliance is installed in cellars, you
must ensure that there is sufficient ventila-
tion.
§ Ducts and wall bushings must be sealed
under and behind the unit to protect
against fire.
44 / 220
§ Do not drill holes in the appliance and do
not carry out any other work on the appli-
ance.
§ Do not crush or bend pipes.
CAUTION
Material breakage.
Falling hazard. Impact hazard due to the pos-
sibility of falling goods. Cuts.
§ Do not climb onto or into the appliance.
Sharp edges of the appliance. Heavy
appliance parts.
Cutting injuries to the hands. Hands may be-
come trapped.
§ Take care of fingers and hands when un-
packing.
§ Wear protective gloves.
NOTICE
Material and property damage due to incor-
rect setup.
§ Operate the appliance in a stable operating posi-
tion (horizontal alignment).
§ Operate the appliance only on the designated ad-
justable feet.
§ Do not expose the appliance to direct heat radi-
ation at the place of installation, e.g.:
- Sunlight
- Artificial external light sources
§ Do not expose the appliance to direct air condition-
ing or ventilation at the place of installation.
§ Do not install the appliance outdoors.
Material and property damage caused by
damage to the doors.
§ Adhere to minimum clearance around the appli-
ance. Doors must be capable of being opened
without obstruction.
Material and property damage due to accumu-
lation of warm exhaust air (heat accumula-
tion).
§ The exhaust air must be able to escape freely at
the top of the appliance.
Minimum clearance from ceiling 1000 mm.
Lower minimum clearance by agreement with the
manufacturer only.
§ Superstructures or false ceilings directly on the up-
per edge of the appliance may only be installed in
consultation with the manufacturer.
§ To blow out the warm air, at least 300 mm must
remain free between the ceiling and any suspen-
ded marketing posters.
Lower minimum clearance by agreement with the
manufacturer only.
Only qualified staff may set up and install the appli-
ance or a group of appliances (assembly, sealing).
AHT Cooling Systems GmbH | en
428175_1_0121