Use As Intended; Information Requirements (Eu) 2019/2024, 2019/2015; Structure And Function - Daikin AHT KALEA GM FR Traduction De La Notice Originale

4 | Structure and function

– Climate class*
– Rated voltage and frequency
– Rate current and consumption
– Refrigerant and quantity used
– Net content
– Date of manufacture
– and further technical data
*Examples of climate classes:
Climate class Ambient tem-
(class) accord- perature [°C]
ing to ISO
23953-2
3
3.3

Use as intended

The appliance is intended for the display of packaged,
deep frozen food products or access to them by cus-
tomers.
For more information, see [see } Chapter 2.2]
3.4 Information requirements
(EU) 2019/2024, 2019/2015
The following information is provided in compliance
with the information requirements of Regulation (EU)
2019/2024 Annex II.3:
a)
The temperature of the appliance is set at the factory
to ensure compliance with the M-package temperature
class specified by the manufacturer. To ensure optimal
storage of the food, it is recommended that you main-
tain this setting.
b)
Changes in the temperature settings can lead to spoil-
age of the food.
c) Requirement does not apply to this appliance
d) Requirement does not apply to this appliance
e)
– [see } Chapter 8]
– [see } Chapter 12]
– [see } Chapter 11]
f)
If the condenser coil is not cleaned once per year, this
can considerably reduce the efficiency of the appli-
ance.
g, h, i, j, k)
– [see } Chapter 12.5]
The following information is provided in compliance
with the information requirements of Regulation (EU)
2019/2015 Annex V.2:
This product contains a light source of energy effi-
ciency class F.
4 Structure and function
The appliance is supplied ready for use and has its
own control unit.
40 / 220
Relative humid-
ity [%]
25 60
The appliance is pre-programmed ex works.
The appliance contains one or more hermetically
sealed refrigerant circuits whose components are per-
manently and technically tightly connected to each
other.
The design of the individual appliance models may
vary.
An appliance group consists of several individual ap-
pliances and is built in a modular design.
A partition wall may be required between the individual
appliances.
1
8
7
6
Fig. 1: Overall view of appliance
Control and display ele-
1 ments,
temperature display
3 Sticker
Mesh basket with remov-
5
able bracket
7 Door
The appliance is equipped with display shelves and
mesh baskets.
Number, position and depth of the display shelves/
mesh baskets according to the loading specification
[see } Chapter 10.1].
The appliance is equipped with doors.
The doors are equipped with a self-closing mechanism.
Door self-closing mechanism
The door closes by itself as of a specific angle.
Appliance models with brine circuit
The waste heat generated in the appliance is trans-
ferred to the external unit via a brine circuit.
NOTICE
Material and property damage due to use of
non-approved components.
§ The connection to a brine circuit for cooling is per-
mitted only on appliances of the manufacturer
AHT.
Appliance models with additional designation AIR
The waste heat generated in the appliance is trans-
ferred to the ambient air via a liquefier.
AHT Cooling Systems GmbH | en
2 3
5
4
Display shelf with
2
bracket
4 Foot panel
6 Plastic panel
8 Door seal
428175_1_0121