ims PRO TITANIUM 400 AC/DC Mode D'emploi page 45

Cold time
Pulse frequency
Duration of the step
* : the step duration setting
exit section to the last one.
the step duration setting allows in 4T mode and with a two-button torch only to switch from Step to press and release button 2.
The advanced settings (accessible in the process menu) :
Parameter
HF level
HF duration
Breaking voltage OFF, 0 - 50 V
Time to break 0 - 10 sec.
Bonding tension OFF, 0 - 50 V
Delay before gluing 0 - 10 sec.
Wizard Alu
This operating mode allows you to pre-assemble or weld aluminium parts. The pre-installed user settings, known as synergies, monitor the work-
piece's thickness and the type of welding joint (butt joint, lap joint, corner joint or fillet joint).
Pre-assembly
Parameter Designation
Thickness
Assembly
Downslope
PreGas
PostGas
JOB MEMORIZATIONS AND REMINDERS
The current settings are automatically saved and loaded at start up.
In addition to the current settings, it is possible to save and recall so-called «JOB» configurations.
There are 100 JOBS per welding process, the memorization concerns:
- The main parameter,
- The secondary parameter (MMA, TIG),
- Subprocesses and button modes.
JOB MODE
TITANIUM 400 AC/DC
1 - 99% Time balance of the hot current (I) of the pulse
0.1 - 2.5 Hz Pulse frequency
, ,
Duration of the Step welding current or trigger mode (*).
0 - 90 min.
allows in 2T mode to manage the duration of the configured section at trigger release, the cycle will end from the
Setting
1 - 10 Index adjusting the voltage from 5 kV to 14 kV
0 - 3 sec. HF time before it stops
Upper arc voltage before stopping the welding generator
Duration of consideration of the breaking voltage
Lower arc voltage before stopping the welding generator (anti-sticking)
Duration of time for taking into account the bonding tension.
Setting
0.5 - 5 mm Thickness of the workpiece
Butt joint, lap
Welding position
joint, fillet joint
0 - 60 sec. Down slope current.
0 - 60 sec. Time to purge the torch and to protect the area with gas before ignition
Duration for which gas is released after the arc has stopped. It protects the weld pool
0 - 60 sec.
and the electrode against oxidisation when the metal is cooling down.
Description & advice
To switch from one mode to another, press
button #4
Welding
Description & advice
EN
.
Pre-assembly mode
Welding mode
Welding only
45