ims PRO TITANIUM 400 AC/DC Mode D'emploi page 43

MUTLI TACK (TIG DC)
This is the same mode as the TIG DC TACK, but with a sequence of scores and defined stopping times as long as the trigger is held in.
Settings Designation
PreGas
Welding current
Pulsed duration
Frequency
of pulsation
Non-pulsed duration
PostGas
Duration between 2
points
Welding in E.TIG mode
This mode allows constant power welding by measuring arc length variations in real time to ensure constant bead width and penetration. In case the
assembly requires the welding power to be controlled, the E.TIG mode can be used as it is designed to ensure that the welding power remains the
same regardless of the position of the torch.
Standard (constant current)
2 mm
D
Wizard Lab
The Wizard Lab mode is only accessible in the «Advanced» display mode and is dedicated to the TIG welding process. It allows the realization of complex
welding cycles (non-standard) by a succession of Steps. Each Step is determined by a ramp and a current level and a type of current (DC/AC/Pulsed) during it.
The configuration of the Wizard Lab is done in three steps: the definition of the welding cycle (number of Steps, loops...), the setting of each Step
(ramp, current type...) and finally the settings of the specific advanced parameters.
TITANIUM 400 AC/DC
Adjustable
settings
0 - 60 sec. Time to purge the torch and to protect the area with gas before ignition
3 - 400 A Welding current.
Manual pulsation phase or of a defined duration
, 0 - 60 sec.
0.1 - 2500 Hz Pulse frequency
Smooth current phase manual or of a defined duration
, 0 - 60 sec.
Duration for which gas is released after the arc has stopped. It protects the weld pool
0 - 60 sec.
and the electrode against oxidisation when the metal is cooling down.
Time between the end of a point (excluding PostGaz) and the recovery of a new point
0.1 - 20 sec.
(including PreGas).
10 mm
5 mm
D D
Description & advice
E-TIG (constant power)
5 mm
2 mm
D D
B1
B2
EN
10 mm
D
43