ims PRO TITANIUM 400 AC/DC Mode D'emploi page 36

1
The arc priming and stabilization device is designed for manual and mechanically guided operation.
Warning: increasing the length of the torch or earth return cables beyond the maximum length specified by the manufacturer will increase the risk
of electric shock.
In «Advanced» HMI mode only, the HF is adjustable in time and voltage :
Parameter Designation
HF duration
Duration HF
HF voltage
HF level
TIG PROCESS SETTINGS
• TIG DC is designed to the welding of ferrous metals such as steel, stainless steel, but also copper and its alloys and titanium.
• TIG AC is dedicated to the welding of aluminium and its alloys, but also copper.
• The Synergic TIG no longer works on the choice of a DC or AC current type and the settings of welding cycle parameters, but integrates experience-
based welding rules/synergies. This mode therefore restricts the number of settings to three basic settings:
- The type of material.
- The thickness to be welded.
- The welding position.
• The TIG Wizard Lab is dedicated to complex applications where classical TIG processes (DC/AC/Synergic) reach their limits and allows for the
creation of customised welding waveforms.
Settings
Standard
Pulsed
Fast
Pulsed
Spot
Tack
Multi
SPOT
Multi TACK
AC MIX
Type of materials
Diameter of the Tungsten
electrode
Type of priming
Trigger mode
Constant energy welding
36
TITANIUM 400 AC/DC
2 3
Adjus-
TIG
Designation table
DC
settings
Smooth current -
Pulse current -
Inaudible
-
pulsed current
Smooth poin-
-
ting
Pulse pointing -
Repeated
smooth poin- -
ting
Repeated pul-
-
sed pointing
Mixing current
-
AC and DC
Fe, Al,
etc.
1 - 4 mm
HF
LIFT
HF.Touch
2T - 4T -
4TLOG
ON - OFF
1- Position the electrode tip on the workpiece and press the torch button.
2- Lift the electrode from the workpiece.
3- After a delay of 0.2s, the arc is ignited without contact using HF high voltage
ignition pulses, the initial welding current flows and the weld is continued according
to the welding cycle.
Setting Description and advice
0-3 s HF time before it stops
0-+10 Index adjusting the voltage from 5kV to 14 kV
TIG Wizard
TIG TIG
Wizard
AC Synergic
Lab
- -
- -
- -
- -
- -
- -
- - -
- - -
- - -
- -
Recommendations
Wizard
ALU
-
-
-
-
-
-
- Choice of the material to be welded
Choice of electrode diameter. Allows to
refine HF priming currents and synergies.
Select Starting Function. In ADVANCED
display mode, the HF is adjustable in time
[0.01s; 3s] and voltage indexed from
[0;+10].
Choice of trigger welding management
2T - 4T
mode.
Constant energy welding mode with correc-
-
tion of arc length variations
EN