Important Application Instructions - Kärcher SC 3 EasyFix Mode D'emploi

Keep the device safe
1. Plug the extension tubes into the
large holders for accessories.
2. Plug a manual nozzle and spotlight
nozzle into each extension tube.
3. Fasten the large round brush to the
spotlight nozzle.
4. Plug the small round brush and noz-
zles into the medium-sized holder
for accessories.
5. Hang the floor nozzle in the park
bracket.
6. Wind the steam hose around the ex-
tension tube and plug the steam gun
into the floor nozzle.
7. Wind the mains cable around the ex-
tension tube.
8. Store the device in a dry location
that is protected from frost.
14
Important application
instructions
Cleaning the floor areas
We recommend sweeping the floor or
vacuum cleaning it before using the
device. In this way the floor will be
cleared of dirt and loose particles be-
fore the wet cleaning commences.
Freshening up textiles
Prior to using the device, always check
the compatibility of the textiles at a con-
cealed point: Steam down the textile,
allow it to dry and then check it for any
change in color or shape.
Cleaning coated or painted
ATTENTION
Damaged surfaces
Steam can loosen wax, furniture pol-
ish, plastic coatings or paint and edge
band from edges.
Do not direct the steam at glued lami-
nated edges as the edge band may
loosen.
Do not use the device for cleaning un-
sealed wood or parquet floors.
Do not use the device for cleaning
painted or plastic coated surfaces such
as kitchen or living room furniture,
doors or parquet.
1. To clean these surfaces, steam a
cloth briefly and use it to wipe over
the surfaces.
English
surfaces