Refilling Water - Kärcher SC 3 EasyFix Mode D'emploi

Note
When steaming for the first time after
removing and reinserting the decalcifi-
cation cartridge, the steam jet may be
weak or irregular, and individual drops
of water may be expelled. The device
requires a short running-in period
during which the decalcification car-
tridge fills with water. The steam vol-
ume that is expelled increases
constantly until the maximum steam
volume has been reached after ap-
prox. 60 seconds.
1. Place the device on a solid surface.
2. Plug the mains plug into a socket.
a Press the ON switch.
3. The green heating indicator light
lights up.
The device is ready for use after ap-
proximately 60 seconds.
60 sec
12
Note
After the cartridge is inserted for the
first time or has been replaced, it takes
about 60 seconds for a good steam im-
age result.
Regulating the steam volume
The expelled steam volume is regulat-
ed using the selector switch for steam
volume. The selector switch has three
positions:
Maximum steam volume
Reduced steam volume
No steam - child lock
Note
In this position, the steam
lever cannot be operated.
1. Set the selector switch for the steam
volume to required steam volume.
2. Press the steam lever.
3. Before starting cleaning, point the
steam gun at a cloth until steam is
expelled evenly.

Refilling water

If there is a water shortage, the red wa-
ter shortage indicator light lights up
constantly.
For constant steam output, the water
has to be topped up through the cover
of the decalcification cartridge. When
refilling the water, the decalcification
cartridge remains secured in the de-
vice.
Note
The device is equipped with dry run-
ning protection for the pump. If the
pump runs dry for a longer period, e.g.
because the decalcification cartridge is
not correctly inserted, the pump
English