Kärcher SC 3 EasyFix Mode D'emploi page 20

otherwise be set automatically to the
last selected water hardness or the
highest water hardness set during ini-
tial start-up.
1. Connect the mains plug.
2. Make sure that the device is
switched off.
3. Press the RESET button and hold it
while switching on the device.
After approximately 2 seconds, the
indicator light flashes and signals
the current water hardness setting
with the number of pulses.
4. Press the RESET button repeatedly
to change the water hardness level.
Note
When the RESET button is pressed,
the flash pulse for the water hard-
ness level is not indicated.
5. Release the RESET button.
The flash pulse for the set water
hardness is indicated.
6. Repeat the procedure as necessary
until the desired water hardness lev-
el has been achieved.
7. Press and hold the RESET button
for 3 seconds to save the setting for
the water hardness level.
The indicator light for the water
hardness lights up.
20
Care of accessories
(Accessories - depending on scope of delivery)
Note
The microfiber cloths are not suitable
for dryer.
Note
When washing the cloths, observe the
notes on the washing tag. Do not use
any liquid softeners as this will affect
the ability of the cloths to pick up dirt.
1. Wash the floor cleaning cloths and
covers at a max. temperature of
140° F (60° C) in the washing
machine.
English