Finishing Work; Cleaning And Maintenance; In The Event Of A Problem - WMF KULT Mode D'emploi

Danger! Never push ingredients into the
container by hand or using another object!
Always use stopper a!

▪ Finishing work

▪ Once the ingredients have been sufficiently
chopped and combined, turn the power
switch o to the „O" position and remove
the power plug p from the socket.
▪ Release the preparation container m from
the motor n by turning slightly in a coun-
ter clockwise direction and remove.
▪ Release lid c dfrom the preparation
container by turning slightly in a counter
clockwise direction and remove (only possi-
ble once the preparation container has been
release from the motor).
▪ Remove the drive shaft l using the tool
and place aside.
▪ Empty the preparation container, using
spatula q to remove the rest of the
ingredients.
▪ Clean all used parts (see next chapter).
Cleaning and
maintenance
Health risk! Clean all parts immediately
after use and remove any remaining food right
away.
Danger! Never wash or rinse the motor!
Do not immerse it in water! Always remove the
plug before cleaning.
Risk of injury! The cutting blades and
discs are sharp! Do not touch! Be careful when
cleaning the cutting blades and discs!
Do not use any corrosive, alcohol-based or
caustic cleaning fluids or utensils containing
solvents (e.g. scouring pads etc.) These could
scratch the surface.
The individual parts must be completely dry
before use.
▪ Clean the motor n with a damp cloth and
dry thoroughly.
▪ Thoroughly clean all other parts with rinsing
water and dry carefully.
16
▪ The preparation container m, lid c, filling
tool b, stopper a, driver shaft l, beating
disc g, stirring blade h, kneading blade
i and stainless steel blade j can also be
cleaned in the dishwasher.
Ensure that all locking and connecting parts
are free of food particles.

In the event of a problem

Faults can occur with all electrical machines.
This does not necessarily involve a defect in the
machine itself.
If the motor is not running, make sure that all
accessories (preparation container, lid, driver
shaft, tools) have been assembled correctly.
There are several safety switches which prevent
the motor from running if the machine has not
been assembled correctly.
If you are unable to fix the problem, please call
our hotline.
Danger!
Never attempt to repair the defective or
suspected defected machine yourself. You may
put yourself and later users in danger. Only
authorised experts are permitted to make these
repairs.