Radio Basic Operations; Listening To The Radio; Searching A Station Automatically: Auto Search; Searching A Station Manually: Manual Search - JVC KD-LX100 Manuel D'instructions

RADIO BASIC OPERATIONS

Listening to the radio

You can use either automatic searching or manual
searching to tune into a particular station.
Searching a station automatically:
Auto search
1
Select the band.
Each time you press the button, the band
changes as follows:
FM1
Selected band appears.
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Start searching a station.
Press
stations of higher frequencies.
Press 4
stations of lower frequencies.
When a station is received, searching
stops.
8
SCM
7
SEL DISP MODE
1 Press SOURCE to select
tuner as the source.
2 If necessary, press BAND
repeatedly to select the
band.
FM2 FM3
¢ to search
to search
KD-LX100
MONO LOCAL INT RPT RND
8 9 10 11 12
SOURCE BBE
To stop searching before a station is received,
press the same button you have pressed for
searching.
To tune in FM stations only with strong signals
1
Press MODE.
"MODE" appears on the display, and the number
buttons can work as different function buttons.
2
Press LOCAL, while "MODE" is still on the display,
so that the LOCAL indicator lights up on the
display.
This function works only while searching FM
stations, including SSM preset (see page 9).
Each time you press the button, the LOCAL
indicator lights up and goes off alternately.
Searching a station manually:
Manual search
1
AM
Select the band.
Each time you press the button, the band
changes as follows:
FM1
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
BAND OFF
1 Press SOURCE to select
tuner as the source.
2 If necessary, press BAND
repeatedly to select the
band.
FM2 FM3 AM