Specific Safety Rules; Tool Assembly; Functional Description - Milwaukee SDS+ Manuel De L'utilisateur

SPECIFIC SAFETY RULES

1. Wear ear protectors. Exposure to noise
can cause hearing loss.
2. Use auxiliary handles supplied with
the tool. Loss of control can cause
personal injury.
3. Hold power tools by insulated grip-
ping surfaces when performing an
operation where the cutting tool may
contact hidden wiring or its own cord.
Contact with a "live" wire will make ex-
posed metal parts of the tool "live" and
shock the operator.
4. Maintain labels and nameplates.
These carry important information.
If unreadable or missing, contact a
MILWAUKEE service facility for a free
replacement.

FUNCTIONAL DESCRIPTION

1 2
7
1. Depth gauge rod
2. Clamp
3. Mode selector lever
4. Control switch
5. Trigger
6. Side handle
7. SDS Plus bit holder
6
Symbology
Volts Direct Current
No Load Revolutions
per Minute (RPM)
5. WARNING: Some dust created by power
sanding, sawing, grinding, drilling, and
other construction activities contains
chemicals known to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well ven-
tilated area, and work with approved
safety equipment, such as those dust
masks that are specially designed to
fi lter out microscopic particles.
3
4
BPM
Blows per Minute (BPM)
Underwriters Laboratories, Inc.,
United States and Canada
4
To reduce the risk of injury, always
lock trigger or remove battery pack
before changing or removing acces-
sories. Only use accessories spe-
cifi cally recommended for this tool.
Others may be hazardous.
Removing Battery Pack from Tool
Push in the release buttons and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool
To insert the battery pack onto the tool, slide
the pack onto the body of the tool. Make sure
it latches securely into place.
Adjusting the Side Handle Position
1. Loosen the side handle by unscrewing
the side handle grip until the side handle
rotates freely.
5
2. Rotate the side handle to the desired
position.
3. Tighten the side handle grip securely.
Setting the Depth Gauge
1. Press in the clamping lever.
2. Slide the depth gauge rod backward or
forward to the desired depth.
NOTE: The drilling depth is the distance
between the tip of the bit and the tip of
the depth gauge rod.
3. Release the clamping lever.
Fig. 1
Drilling
Depth

TOOL ASSEMBLY

WARNING
Installing Drill Bits and Chisels
NOTE: Only use accessories with SDS or
SDS Plus shanks.
Be sure that the shank of the bit is clean.
Dirt particles may cause the bit to line up
improperly. Do not use bits larger than the
maximum recommended capacity of the drill
because gear damage or motor overloading
may result. For best performance, be sure
that the bit is properly sharpened and the
shank is lightly greased before use.
1. Insert the bit or chisel into the nose of
the tool.
2. Rotate bit slowly until it aligns with the
locking mechanism.
3. Push bit into tool until it locks.
4. Check that the bit is locked properly; it
should be possible to pull the bit back
and forth slightly (about 1/4").
5. To remove bits and chisels, pull bit
holder release collar toward the rear of
tool and remove bit.
NOTE: Use caution when handling hot
bits and chisels.
Fig. 2
Release collar
5