Specifications; General Information; Safety Information - Hach SP-510 Manuel D'utilisation

Specification
Storage temperature
Operating humidity
Sampling rate
Sample flow rate to sample conditioning 50 to 500 mL/minute flow rate necessary (250 mL/minute
Inlet pressure to instrument
Inlet pressure to sample conditioning
Inlet fitting
Drain fitting
Sample temperature range
Certifications
Warranty
Trip point specifications
Alarm trip point Minimum trip value
0.3 mg/L 0.22 mg/L
1 mg/L 0.75 mg/L
2 mg/L 1.5 mg/L
5 mg/L 3.75 mg/L
10 mg/L 7.5 mg/L
20 mg/L 15.0 mg/L
50 mg/L 37.5 mg/L
100 mg/L 75.0 mg/L
Section 3 General information
In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

3.1 Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
4 English
Details
-40 to 60 °C (-40 to 140 °F)
Relative humidity: 5–95% at different temperatures, non-condensing
New sample: every 1.9 minutes ±5% at 60 Hz; 2.3 minutes ±5% at
50 Hz
recommended)
1 to 5 psig (0.07 to 0.34 bar), 1.5 psig (0.1 bar) is optimum, > 5 psig
(0.34 bar) can cause sample tubing failure
1.5 psig to 75 psig (0.1 to 5.2 bar)
At instrument, 6.35 mm (0.25 in.) OD polyethylene tubing with quick-
disconnect fitting
Hose barb for 12.7 mm (0.5 in.) ID flexible tubing
5 to 40 °C (41 to 104 °F)
CE, cETLus
1 year (EU: 2 years)
Maximum trip value
0.38 mg/L
1.25 mg/L
2.5 mg/L
6.25 mg/L
12.5 mg/L
25.0 mg/L
62.5 mg/L
125.0 mg/L
N O T I C E
Temperature influence on trip point
–0.03 mg/L per °C
–0.03 mg/L per °C
–0.03 mg/L per °C
–0.06 mg/L per °C
–0.08 mg/L per °C
–0.09 mg/L per °C
–0.29 mg/L per °C
–0.60 mg/L per °C