Door/Window Sensor - Acova Z23020 Notice D'utilisation

RF_prog:RF_prog_ACOVA_7L 22/10/2010 09:20 Page47

5.2 Door/window sensor

A door/window sensor using the X2D standard can be used to automatically stop
the appliance heating if a window is opened, for example.
To enable this, you need to:
_ install and connect your appliance (see section 1)
_ associate your appliance with the room thermostat (section 4.6)
_ associate your appliance with the door/window sensor (not supplied)
To do this, press the
AUX light blinks.
Press the association button on your opening detector. The AUX light will go out,
indicating that the association was successful.
The radiator is now associated with the door/window sensor.
The TH light is glowing steadily
(the radiator is associated with the thermostat)
NOTE You can associate up to 8 sensors over the
described above for each sensor you wish to associate.
Once associated, the
5.3 Resetting the associations on your appliance
To clear all the associations between your appliance and the various X2D
devices it is associated with (including the room thermostat supplied), press
the button for 60 seconds.
The TH light will start to blink, showing that it is waiting for a new association
signal.
NOTE To cancel the associations on the
seconds.
AUX
The
indicating that the disassociation has been successful.
button on the appliance receiver for 3 seconds until the
3 sec
AUX
light will illuminate when a window is open.
light will blink after 3 seconds then go out altogether after 10 seconds,
The AUX light goes off when the association
signal from the door/window sensor
has been received
AUX
bus. Repeat the operations
AUX
bus only, press button
EN
for 10
47